External Screen Case for Ender 3
Description
I made this external case to place the screen under the printing bed if you have a tight space for your printer or if you want make it external. The feet are high enough to allow the cable pass under the case but also low so it don't touch the printing bed. Print the case with the outside facing down and the four feet sideways. Maybe you will need a little support on the curvature feet. You will probably need to sand the to make the board and the feet fit in place. You also may put a stop on the plate control wheel to raise it so that it does not touch the leg closest to it. Leave your suggestions for changes in the comments.
Statistics
Likes
5
Downloads
0