Bosch Professional 'GKT 18V-52 GC' plunge saw french cleat mount
Description
###What you need to build this thing: - 12x screw 4,1x25mm - 2x M3 washer - 4x M3 nut - 2x M3x10 hexagon bolt - 2x M3x30 hexagon bolt (depends on your mounting plate) - mounting plate (min. 330x200mm; I used an OSB plate with 18mm thickness) - approx. 100mm cleat for backside of your mounting plate, depending on your french cleat wall ###Print: - in principal you only need part 1 to hold the plunge saw in place - the other parts are suitable for alignment when remove the saw from the wall and reattach it as well as for more safetyness - I printed all parts with 100% infill - only used supports for nice finish of the bolt heads and nuts pockets, respectively. Possibly you don't need it. ###Assembly: - add the nuts in the pockets of holder 1 and 3.1; if they fit too tight, use a M3 bolt - print the prepared *.pdfs for alignement of drilling holes - cut along the markings - align the halves and tape them - position the paper on your mounting plate (use the center lines if you like) - drill the holes (I used 5mm drill bit for 4,1x25 screws and 3,5mm drill bit for the M3x30 hexagon bolt to get a loose fit) -- drill stand is recommended -- - attach holders 2L, 2R and 3.1 with the 4,1x25 screws from the back of the mounting plate - attach holder 1 with the M3x30 bolts from the back of the mounting plate - be sure to countersink the heads of the fasteners so that they are flush with the back of the mounting plate. - assemble holder 3.2L and 3.2R to the 3.1 holders using the M3x10 bolt. Insert the M3 washer between the two parts for a smooth opening of the hinges. - add your cleat on the backside Have fun!
Statistics
Likes
11
Downloads
0