Ubox Mount/Case
Description
Spintend Ubox Mount and Enclosure Designed this to mount the new spintend ubox vesc to my mbs deck and to make it partially waterproof. Had to go through trial and error to design and print a final product that did not break. This should not break if printed and installed correctly. Designed for a 30 degree angle but should work fine with any angle it just will have the vesc sitting flat at 30 degrees. The mount base to the deck should definitely be printed at 100% infill and with petg or any filament that you think would be durable enough(nylon, carbon fiber, etc.). It will not break even on the most bumpy trails if done right. All you will need is m3(5),m4(12) bolts no longer than 14mm and some nuts. possibly 2 longer bolts and nuts for the mount base to the deck and trucks. You will also need a small sheet of plexiglass, policarbonate, etc. and cut it to fit the top. Glue/caulk it in place. Check out my final design of this, here is the link. https://cults3d.com/en/3d-model/various/spintend-ubox-enclosure
Statistics
Likes
0
Downloads
0