Drag Chain (cable routing chain) for 3D printer
Description
This is a scaled down version with a lower profile (15mm bend radius) that fits neatly and completely under the Prusa i3 heatbed. Outside measurements are 19mm wide X 10mm high. inside measurements are 9.5mm wide X 6.5mm high. Lower profile was achieved by scaling down the original and cutting an additional 22.5 degrees off of the chain angle. Three different end pieces allow for different mounting options. "Outside End Prusa i3" mounts to the bottom plywood frame of the Prusa i3
Statistics
Likes
0
Downloads
0