Spices holder / stand
Description
#Spices holder ##Description <p>This is a spice holder designed for small spices tubes (~45mm diam, ~10cm height).</p> ##Parts to print * plate.stl (x1) : ~7,5 hours at 50mm/sec print speed * holder.stl (x6) : ~1,5 hours at 50mm/sec for each holder, less if multiple prints at once Total print time : ~15 hours ##Assembly <p>The holders fits right into the plate, there is no need to glue them but I did it anyway just to be sure they won't pop out.</p> ##Notes <p>On the pictures there is no reinforcement on the bottom plate, I added it after printing to make it a bit stronger but I didn't printed the piece again as it was strong enough as it.</p> <br> <br> #Print settings ##Quality * 0.2mm resolution * 20% infill ##Supports * No supports * No raft
Statistics
Likes
5
Downloads
0