Wire beak holder
Description
#Beak for wire holding. > I remixed this **wire beak** (original beak design by charlesmouse for his Wire Bird) to go with Cybertron3D's third hand solder helper. *8.25mm sphere* and fits directly into the female cup. I remixed it because I found it was impossible to print the original version without any supports. You print this standing up. *Print slowly* to get the first layer adhesion as it's a small area. I had my first layer printing at 5mm/s because it's PETG and the filament is sticky and tends to want to pull. You can probably print this faster in PLA. >It's not meant to replace the crocodile clips but in COVID-19 times, you might need something printed to use immediately instead of waiting for an order to arrive. ### Thanks for looking and using this! ### If you like my design, and are feeling generous, feel free to leave me a ***tip***! ### Check my page out often for ***more designs*** as I continue to create and design stuffs! # Happy **3D-ing!**
Statistics
Likes
3
Downloads
0