Ryobi 18 volt battery single, dual, and quad sockets.
Description
I was inspired by this design: https://www.thingiverse.com/thing:2955475, but my slicer wasn't able to read the information correctly so I searched, and found a better holder here: https://www.thingiverse.com/thing:3340651. Slic3r has a built in utility to cut an stl file, so I used the basic plate to create single, dual, and quad Ryobi battery sockets then use 123D Design to assemble the pieces. I have two quad holders on a Razor EcoSmart Metro scooter to get 36 Amps of battery capacity. Each battery is 9 Amps with each set of two batteries in series. Four sets are in parallel.
Statistics
Likes
5
Downloads
0