Nerf to paper dart converter
Description
This a barrel insert for the nerf Firestrike, Jolt, Nitefinder, or any pistol you can fit this thing into. For each gun, it might take a little sanding or electrical tape to get the right fit. The biggest known weak point is right where the 2 tubes seem to connect, it should be printed at LEAST 80% infill to ensure that doesn't break. To make the dart, you roll up a small piece of paper to make a tiny cone, tape it, then put the cone gently into the small end of the tube. Cut it off there, then put it back in the barrel, put the barrel in the gun, then shoot it. If it doesn't shoot, push the dart out using a knitting needle or something, and trim a little bit off of it. Optional nail in the tip of the dart but that's hella dangerous so don't do it, I won't be held responsible for your actions. This is not a toy and should be treated as an actual firearm, the speed of these darts can reach over 150 fps when created correctly, so be careful. 7/15/21: The files have been removed, but are now available on etsy: https://www.etsy.com/shop/RandomFusionModels
Statistics
Likes
2
Downloads
0