Levitation Curved honeycomb vase
Description
This is a Remix from Eggnog Curved Honeycomb Vase. First, I've reduced in size (75% of the original) the model. I've modified the source so we can place a 50mm diameter magnet under the vase. I've made a hole on purpose so it can print faster, and later print the bottom part to glue under. If time is not a problem, I've also added the source without the hole, so the vase should be waterproof. Not tested though. The levitation kit I've used can support a weight up to 500g (usually other kits only allow up to 250g). with the light weight of the vase, should be good to add a few flowers and a bit of water.
Statistics
Likes
15
Downloads
0