Hyperfire Belt drive pulley and guide upgrades
Description
Here are a few Hyperfire belt pulley and guide parts, along with a trigger switch replacement for the 10A micro snap switches. The pulleys have one extra tooth in them to take out the slack in the belt so that the outer teeth on the belt do not bend over when they are supposed to engage the darts. So far it is working very well. I printed in Ultimaker CPE+ You may need to remove just a little bit of material around the belt for the dart pusher teeth to fit cleanly. Re-use the belt retainers that came off of the original pulleys
Statistics
Likes
1
Downloads
0