PTFE to PTFE Straight Connector - 2020 Extrusion Mounted
Description
This is a connector I designed to splice two 4mm OD/2mm ID PTFE tubes. It's meant to be mounted on a 2020 extrusion, but can be put on a flat surface, as well. # Using two PC4-M10 couplers The channel for PTFE tubing between the connectors' ends is only 6mm deep. To make sure your PTFE tubes meet within the channel, screw in one connector and thread in some PTFE until you can tell it's made it into the channel. Then screw in the second connector. # Bulkhead coupler version 2021-2-12: I added a new file that takes a bulkhead union coupler that only needs one connector. They can be hard to find, so there's an Amazon link below. Beduan sometimes sells five packs, too. Because of the width of the coupler, this can't be mounted across a pair of 2020 extrusions or a 2040 extrusion, but it can be mounted sideways. # You will need - 2x M4x8mm screws with tee nuts - 2x PC4-M10 PTFE couplers (PTFE to PTFE coupler.stl) - **or** 1x [4mm/4mm OD bulkhead union quick connect coupler](https://www.amazon.com/uxcell-Straight-Pneumatic-Fittings-Bulkhead/dp/B07Z2TXMJH) (PTFE Bulkhead Coupler Mount.stl)
Statistics
Likes
26
Downloads
0