Filament Guide for table mounted spools
Description
I like the idea of the TUSH Filament spool holder https://www.thingiverse.com/thing:2047554 But for me I am using Direct drive so this presents a challenge where the filament needs to go up and then come back down into the top of the hot end. So I designed this filament guide to go on top of the printer Using the same 608 bearing as the TUSH getting a bigger pack is easier. This has a spacer for the middle of the bearing, it is using an M5 bolt to be able to keep it in place, however you can 3D print the pin if you would rather. Just uses 2 bolts and T-nuts to secure it to the top rail. No need for supports and a simple print !
Statistics
Likes
2
Downloads
0