Dessicant box floor 100mm x 150mm x 22.5mm
Description
I wanted to raise myspool off the silica gel pellets in the bottom of the box. For one thing my box is too narrow at the bottom for the spool to rotate freely. Also the Tush spool holders I'm using fall over on the uneven surface of the silica. So I made this little grated table / floor for the tushes to sit on. Keep your filament dry and it will treat you well. My first layer adhesion is way way way better since I've started using a dessicant box and a bit of teflon tubing to protect the filament. Petg especially. My PETG is now printing better than the previous roll of PLA was.
Statistics
Likes
1
Downloads
0