spin tail lure 35mm
Description
Body of a spin tail lure. The lure is printed in two halves and then glued together. I made three small holes with 2.5mm depth on the inner side of each piece. Together with the holes, a PLA filament cut in 5mm length can be used as a tenon when you glue the lure. Two bigger holes are for placing sinkers. A ball-bearing swivel is to be attached to the tail part so that a metal blade rotates correctly. The finished products shown in the uploaded photo are printed with fluorescent filament. I hope this works well in night use.
Statistics
Likes
6
Downloads
0