Z SPACER FOR ENDER 3 V2- PERFECT STEPPER & LEADSCREW ALIGNMENT
Description
This is a spacer for the Z stepper motor on the Ender 3 V2. *This is probably compatible with other Ender 3's, though I don't have any other than my 3v2 to confirm.* I was unhappy with other designs that I came across, mostly due to lack of adjustability for correct placement of the stepper in the X and Y direction. There are 3 versions- for M3, M4 and M5 T-nuts. **You will need:** 4 x M3 bolts, 7 - 10mm long (I used 8mm) 4 x M3 washers **Additionally:** 2 x T-nuts suitable for use in 2020 extrusion 2 x Bolts which fit the thread of T-Nuts 2 x Washers to fit Bolt size **Instructions:** Assemble the spacer & stepper- leave M3 bolts slightly loose to allow adjustment. Note: the stepper jst connector should be on the same side as the 1st layer Add the T-nuts, T-nut bolts & washers to the assembly. Slide assembly along 4040 extrusion to desired position. Once good alignment is found in the Y direction (parallel to the bed movement) tighten the T nuts to lock the assembly into position. Align the stepper in the X direction (parallel to the print head movement) and tighten the M3 bolts to lock the stepper into position. When tightening bolts, ensure that parts don't move. Done.
Statistics
Likes
60
Downloads
0