Elegant E3D / BLTouch Conversion kit for Ender, CR-10, Tevo printers, etc.
Description
I wanted to put a E3D V6 on my Tevo Tornado but everything I found on Thingiverse was too blocky and rough looking or too big and over the top, like an octopus humping a fan. The standard 40mm blower fan works great blowing from the side. There is no need for multiple giant fans This is my take on a finished, elegant looking set of parts to adapt a E3D V6 and a BLtouch to any CR10 type 3D printer. Note that the nizzle tip is now 10mm further forward and 5mm to the left of the stock position. This should not limit the work envelope with most printers. After you mount it up print a few layers of a 100mm cube and take some measurements. This will let you know what X and Y offset figures you need to change to get prints in the center of your print bed.
Statistics
Likes
47
Downloads
0