Battery Dispenser/Holder Remix (70g filament 8.30h)
Description
After the production of the original dispenser from socialjoker, i was impressed about it, but the filament weight and print time needed with 11.40h and 114 g filament was to much to me. I needed a further one and therefore reduced the wall thickness by 50%. from 2 mm to 1 mm which seems quite enough for me for just a battery storage box. See my production picture attached. I have also uploaded my final gcode which includs some small rafts around the print. It prints perfect without support just small rafts around for safety reasons, to avoid warping on the edges happend with the first original print. Needs now only 70 g of filament and 8.30h to print with resolution 0.2 and 100% infill material PLA. Hope you can use it like me.
Statistics
Likes
7
Downloads
0