Ender 3 V2 Wiper Brush Holder
Description
This is a remix from https://www.thingiverse.com/thing:398515 With the Ender 3 V2 the belt tensioner conflicts with where the mounting side on the right would usually line up so I redesigned the back mount to go out just a tad to fit around the tensioner. It's a bit tight but the original screw will still work. Along with this setup I used the G-code from the post below and added just an extra wipe to make sure it would get everything. https://www.thingiverse.com/thing:4067406 M211 S0 ;SOFT ENDSTOPS OFF G1 X235 F4800 G1 X250 F4800 ;WIPE NOZZLE G1 X235 F4800 G1 X250 F4800 ;WIPE NOZZLE G1 X235 F4800 M211 S1 ;SOFT ENDSTOPS ON
Statistics
Likes
18
Downloads
0