Wedding Band for Fidgety People (it spins!)
Description
This is a wedding band for people who like(or don't like) to fidget. Whether trapped in your own psychosis or just wanting to waste some stress, this wedding band may indeed be for you. I made two sizes. 110 is slightly larger than 105. These are just reference numbers as I was changing the scaling in blender. Just measure your finger's diameter and resize it as you see fit. No finger is the same finger. The only trick to making this ring, is knowing and setting up your printer to pause at a certain layer. It should pause right at the moment the top half of the inner ring begins to cap-off the ring. You can then plop the outer ring onto the inner ring and continue printing it to completion. Being that this is a ring, it will require some cleanup. I just went around the edges of mine with a razor. Also, this being a ring, you're probably going to want to have your fan off for most of the print. Bed adhesion kind of matters when only the bottom edge is mating to the print bed. To start the outer band spinning, just squeeze the outer ring after it cools off the bed, it will slowly snap away from the inner ring and become loose. If you have issues, a razor blade may be able to help get you started. Just don't stab through the ring... or yourself.
Statistics
Likes
11
Downloads
0