Spool Holder Snapmaker
Description
Spool holder for Snapmaker 2.0 Material required: - 1x M4x15mm - 2x Ball bearing (inside Ø8mm / outside Ø22mm / width 7mm) Assembly: - Remove the filament holder rod - Put a ball bearing on one side of the rod (mine was nor perfectly round so i had to use a bit of sandpaper) - screw in the filament holder screw on the side with the mounted bearing - push the rod into the 3D printed cylinder from the side with the big diameter - push on the filament holding screw inside the cylinder while pushing in the next ball bearing from the other side - put the M4x15mm screw thru the hole of the filament holder sheet - Place the washer on the screw (this is a distance holder so the 3D printed cylinder will not touch the holding arm) - tighten the M4x15 while holding the filament holding screw tith your finger Do not over tighten the screw otherwise the assembly will not turn as free as it should! in addition i used anti slip tape with a rough surface to cover the surface of the cylinder (this prevents the spool from slipping)
Statistics
Likes
2
Downloads
0