Quick Release for Radio Shack RST-84V Tripod and maybe others
Description
Going through my projects and can use a tripod. Well, I happen to have three Goodwill Store $5.99 or less tripod finds I invested in over the years that were missing the quick release. Decided to make new quick releases with the DesignSpark Mechanical software, maybe some 3D Builder if needed for quicker splits and merges and the Monoprice Select Mini V2. I uploaded both the .slt and the .rsdoc file in case you want to modify the .slt since is a tight fit. Thinking can round the edges a little for the catch mechanism since snaps in and has to be pried out, under each lip going from side to side carefully, without anything attached. I also wound up uploading the first versions rsdoc and slt file that does not have rounded bottom side corners, slightly oversized by maybe a few mm in the back for the clasp and slightly under a mm wider on each side. I also raised the catch area to be slightly higher and rounded out the interface some more to shorten by a mm or two. I think the version 2 can be a little snugger fit and the version one is not going to fit without trimming off the back end and sides from my experience with some rounding on the bottom and back side. However, rounding out all the bottom side edges might also improve the ability to print without supports if your printing isn't calibrated to bridge with the print setting you're using. Added a third updated version including a Go Pro mount remix version of the version 2 quick release with the top GoPro Zip Tie mount 2 by tmorris9 GoPro mount split section: https://www.thingiverse.com/thing:84747 Hope this helps and rescues what would be neglected or trashed and not saved!
Statistics
Likes
0
Downloads
0