Magnetic Z-probe semi-automatic
Description
The "Hex-Key" Z-Auto Probe Sucks.... At Least Mine Did. I Designed This To Use With An 8Mm Diameter X 3Mm Magnet. I Attached A Small Metal Tab On The Bottom Of My Effector For This To Mount To When I Want To "Calibrate" The Flatness Of My Kossel Mini Bed. It Uses The Standard Micro Switch Only.... No Other Moving Parts. I Get Great Prints Using This. Make Sure To Install The Switch With The Roller Tip Under The Magnet, To Prevent Any Wobble/Tipping. The Magnet Is Epoxied In. You Will Also Have To Make Your Own Steel Tab To Bolt To The Bottom Side Of The Effector - In The Pics You Can See I Left It A Tad Too Long (I Wasnt Sure If I Was Going To Add A Second Magnet). Update: This Is A Magnetic Mounting Point For My Magnetic Z-Probe Semi-Automatic. My Original Design Used A Steel Tab For The Magnet To Attach To; Not Everyone Will Want To Or Have The Means To Fabricate The Metal Tab The Way I Did, So This Is A Printable Part That Gets An 8Mm Diameter X 3Mm Magnet Epoxied In..... For The "Magnetic Z-Probe" To Attach To. If You Print And Use This, Let Me Know How It Works Out, As I Have Not Put It Through The Rounds..... Should Work Fine Though.
Statistics
Likes
21
Downloads
0