Ender 3 Pro LCD/Pi 4/TFT 3.5 E3 Case
Description
UPDATE: I had a request for the same cover except for the Raspberry Pi 3, so I have added it. I found a model of the Pi 3 to use for a template, so if the model was accurate, it should work. I liked the idea of having the LCD and Raspberry Pi 4 in the same case. I have the BigTreeTech TFT 3.5 E3 touch screen and the original case did not have holes for the USB and SD card slots on the Touch Screen, so I modified it. Two changes made from original case: 1. Added access holes for the USB port and Memory Card slot on my TFT 3.5 E3 LCD screen. 2. Added some supports underneath the bed where the Raspberry Pi 4 is mounted. While my Ender 3 could manage the bridging of the original file, it was kind of messy and needed to be cleaned up. With the added walls underneath, the only supports needed for this is along the left side and left back corner. Word of note: If you use this case and a USB thumb drive, the actual LCD board sits back from the wall of the case quite a bit. You will either need a USB extension cable for it or a USB stick where the case for the USB is a fair amount of distance back from the actual connector.
Statistics
Likes
29
Downloads
0