TX16S Neck Strap Balancer
Description
The TX16S is a little heavy on the bottom, this neck strap balancer is made to shift the weight up slightly. Print without supports, & 100% infill for strength. Use brim when printing. Read below before printing! * I made the pins with very littler tolerance, make sure your temp is not to high so to avoid over-extrusion. * Make sure to file the pin holes so the pin slides in with slight friction. * Some filing will be needed to make surfaces are as flat as possible ( it took me 5 min to file the interfaces smooth so they fit snuggly).
Statistics
Likes
14
Downloads
0