Hinged Treasure Chest with Latch ( Multi Colour )

Description

Here is my design of a little treasure chest. Inspired by: https://www.thingiverse.com/thing:4652955 But it was lacking a bit of detail... so i thought why not model a new chest with a latch and add a padlock? For assembly you will have to sand the parts for best fitment, aswell as use screws and glue to hold it all together. Here is the link for my Padlock that you can see in the pictures: https://www.thingiverse.com/thing:4733670 Number of parts to print: 1x Bottom_Frame_Front 1x Bottom_Frame_Rear 2x Bottom_Frame_Side 1x Top_Mainframe 2x Top_Frame_Side 1x Top_Frame_Middle 1x MainBody 1x Latch 31x Screwhead_Cap Non-Printed Parts: 2x 1,25x46mm metal rods (or nails) for the rear hinges 1x 1,25x30mm metal rods (or nails) for the latch hinge You could also drill the hinges with 2mm drill bit and use 1,75mm filament as rods for the hinges, but i had these metal rods laying around. 17x M3 Screws were used. i used an assortment of lengths from 6mm to 12mm 6x M3 Nuts I recommend printing the parts in their original position. Use supports for Top_Frame_Middle and Bottom_Frame_Rear Use Raft for Top_Wood To print the 31 Screwhead_Cap i used two perimeters with no infill and no top & bottom layers. Then i added a modifier after 1,6mm in Z-direction with 1 perimeter and 100% infill. This made the caps fit flush over the screwheads to the frame. Edit: added: Bottom_Frame_Front_V2 Bottom_Frame_Side_V2 Bottom_Frame_Rear_V2 These models have the Screwhead_Cap models integrated where there are no screws used. So now you have to print only 17 Screwhead_Cap

Statistics

Category

Tags