Gaskets for Pi Zero Screwless Camera Housing
Description
These are a set of gaskets and plugs for the [PiZero Vertical Screwless Camera Housings](https://www.thingiverse.com/thing:1709013). I really liked this case design, but a couple of holes made me worried about it's suitability in environments where splashing or dust are an issue. These gaskets and plugs attempt to solve the issue! For even better performance, try using these with a sealant! ### Vent Plugs These plugs can be inserted into the vents on the rear of the original design. I haven't tested these in a variety of environments yet, but I've found them to work well in cold and temperate environments, your mileage may very in hotter environments. ### Camera Module 1.3 Gasket This block is designed to be placed on a Raspberry Pi 1.3 camera module to provide some additional protection around the camera opening. This part can be put on the camera before sliding the module into the case. I haven't tested this with any other camera! ### Plug Gasket This tiny print can be snapped around the micro-USB ports to provide some protection to the ports. The micro-USB ports should hold on to this print. After snapping this part on, you can slide the Raspberry Pi Zero back into the case. You should be able to squeeze the gasket between the case and the vertical clamp standoff frame. Everything should slide together! ### Disclaimer No warranty on this! I designed this for use in a covered, outdoor space (Under a house's eaves). There's still plenty of ways for water to get in this case! Don't break your Pi!
Statistics
Likes
3
Downloads
0