Pulley Cover for AnyCubic i3 Mega (rear only)
Description
Note: If you have trouble downloading this model, you can also find it here: https://www.prusaprinters.org/social/55222-tyler/prints This is a pulley cover for the rear Y axis pulley on the Anycubic i3 Mega (I guess it's a gear attached to a stepper motor, not exactly a pulley, but that's what everyone is calling it so we'll go with that) I decided I wanted some pulley covers, and I found one that someone else made for the front, but not too many for the rear. I didn't like the look of the ones I did find for the rear, and the one I tried sat higher than I liked, and also didn't stay flat well because it was only held down on one side. This is a bit lower profile, and attached with two screws to help keep it lying flat. Check out my other Anycubic i3 Mega accessories! https://www.thingiverse.com/dtylerb/collections/my-anycubic-i3-mega-designs
Statistics
Likes
8
Downloads
0