Solderless key switch connector
Description
[UPDATE] Added v2.1 (iteration 30) smaller tolerances and re-adjust of all holes, now the contacts are downward the pins of the switch, modifications adds some time to the print (2 minutes aprox.) but will work better when your printer is more precise (I found that; on transparent pla holes are smaller, on black pla, holes are bigger and the pieces are overall more accurate to the design) Previous versions will work ok on some printers/filaments, and in others will have tolerance issues, since this print is a quick print I sugest that you try the one you think is better first and if it doesnt work as intended try with another one. Tried to make a minimum mount friction based for gateron switches (the ones I have). This is a work in progress, Print in 5 minutes and an important part of it is the raft so mass printing should work fine. If the upperhole is not making contact, just add a small piece of the same material from the diodes throught the upper hole, that will add pressure. Im super cheap person, so you can use the cables on your diodes to make everthing work. Added v1.5 in some prints (in my printer) the upper connector get a little loose, so I added a notch for increase presure on that hole, this version is not tested.
Statistics
Likes
22
Downloads
0