Quarter Turn Toolfree Small Filament Holder
Description
Quarter turn filament holder suitable for v-slot 3D printer such as anycubic and creality. The standard filament holder on my Anycubic Mega Zero was too big to fit 250g reels onto it so I made this to give a minimalist solution for small sample reels. The filament holder should be held on its side and inserted as far into the slot as possible, turn it 90 degrees anti clockwise and it will lock into place and be ready to use. Turn clockwise 90 degrees to remove. Designed to be as small as possible and use minimal material. Uses 6g of PLA and takes 2 hours to print at high quality. Used as a small (250g) filament reel holder and for parts less than 200mm high (or the print head may clash with the bottom of the reel) I'm working on similar designs for larger reels and to allow the print head to extend to the full height without clashing
Statistics
Likes
1
Downloads
0