CR-10/CR10-v2/3 Filament_Sensor_Top_Rail_Mount
Description
For those who have the CR-10v2 which they have modified with a Direct Drive extruder, the Filament Runout Sensor is normally mounted in a very bad location, making the filament path very bad. This mod allows you to move your runout sensor and clip it to the top rail. You WILL have to extend (or replace) your wires to the sensor to let them reach (be very careful if extending that you get the wires oriented properly as the original - otherwise you can literally blow out your motherboard). I've included the Cura .3mf project file which has not only the .stl (showing my preferred orientation on the bed) but also my settings I used. I recommend either using it, or doing your own reinforcement of the critical areas that are stressed when installing or removing it from the top rail. The Cura settings I used print this in a little over 2 hours. CR-10s shown below because damn Thingiverse will never add the newer printers such as the CR-10v2/3 to their lists.
Statistics
Likes
8
Downloads
0