Ender 3 Extruder Guide for Dual Gear
Description
Not a remix, but designed from the idea in https://www.thingiverse.com/thing:2605108 Guide to run filament straight into the extruder This is on a 3 v2 with dual gear extruder, which I think feeds in higher than the stock; try it if you want. features: -filament goes straight into the gears -a short piece of 2/4 tubing can also act as a strain relief (as pictured) if the spool is not inline -hot end wires are routed between the Z rod & frame -there's a tunnel for a zip tie on the wires if you'd like I like this design because feeding filament goes in the 1st time! --1 put a short piece of tubing on the filament --2 feed the filament through BOTH sides of the extruder freely --3 then put the tubing in the guide
Statistics
Likes
6
Downloads
0