XY2_pro_UP
Description
This modification I'm using a 5015-24v fan * Please note that the polarity of the fan electrodes may be reversed. This time, this board is used for power branching. I used it separately https://akizukidenshi.com/catalog/g/gP-12019/ As a part XH connector * 3 https://akizukidenshi.com/catalog/g/gC-12247/ Also if necessary Use XH connector housing and XH contacts https://akizukidenshi.com/catalog/g/gC-12255/ https://akizukidenshi.com/catalog/g/gC-12264/ Terminal block 2 pin * 2 https://akizukidenshi.com/catalog/g/gP-02333/ 220μF 35v * 2 for noise prevention https://akizukidenshi.com/catalog/g/gP-02718/ I'm using fan_holder_base-ABS.stl It will be the base for board mounting and fan_holder_HE-ABS.stl mounting. M3 nut * 5 M3 screw 10mm * 2 M3 countersunk screw 10mm * 2 The power supply branch board of the example uses a cut (17 * 9) board. The example uses an XH connector, According to the availability of tools you have Terminal block Pin hitter, pin socket I would appreciate it if you could change it to a combination. fan_holder_HE-ABS.stl Cover the heatsink and install the 4010 fan M3 screw 10mm * 3 M3 nut * 4 4010FanCover.stl Cover the left side of the 4010 fan (not required) M3 screw 20mm * 2 fan_holder_sty-ABS.stl 4010 Covers the right side of the fan and is fitted with fan_holder_Fnozru-ABS.STL. M3 screw 20mm * 2 M3 nut * 2 fan_holder_Fnozru-ABS.STL 5010 fan can be installed LED can be attached (not required) M3 screw 10mm * 2 M3 screw 20mm * 1 M3 nut * 1 When installing the LED M3 screw 10mm * 1 LED * 2 3KΩ * 2 The rest of the cut board (7 * 4) is required Proximity sensor installation-ABS.stl With X end stop Install the guidance sensor M3 screw 10mm * 6 M3 screw 20mm * 2 M3 nut * 2 X-RibbonCable-GuideM3.stl Using the two screws on the left side of the X motor, Holds the ribbon cable and the X end stop cable. RibbonCable-GuideBottomM3_ABS.stl Holds the ribbon cable protruding from the bottom of the main unit. (Not required) M3 screw 10mm * 4 T-NUT_M3x2.stl RibbonCable-GuideBottomM3_ABS.stl Please use when the attached self-forging T-nut is poorly formed.
Statistics
Likes
2
Downloads
0