Vitamix Tamper Holder V2
Description
This is an update of https://www.thingiverse.com/thing:4171210. The previous design could cause some wear to the tamper end which this version attempts to correct. The tamper holder slides on to the bottom edge of the Vitamix (right of left side). No other attachment is needed. I use a 5 mm felt pads on the bottom of the tamper holder and Vitamix feet allow it to slide around the counter as I keep mine under overhead cabinets and need to pull it out to use it. I printed this at 0.3 mm layer height and 0.5 mm layer width using PETG filament. (use what works for you). No clean up usually required when printing at a slower speed. You'll need to print the main body and 4 side rails. The rails slide on to the guides on the main body in one direction only!
Statistics
Likes
3
Downloads
0