Skywatcher EQ6 RaspberryPi mount
Description
UPDATE 18th of Feb 2021: if using the new version with the enlarged platform AND the USB HUB only 3 screws can be used to attach the platform to the mount! However no prolem with this. UPDATE 15th of Feb 2021: added a new version with space for an additional USB3 hub: http://www.amazon.de/dp/B07P6MPXJ7/ ENGLISH: When using a RPi with an astronomical mount there can be a lot of cable spaghetti around the moving parts. Therefor I designed this platform attached to a Skywatcher EQ6R Pro. Since I did not have a EQ6, EQ6R or any other type of EQ6 I do not know if it will fit to these mounts. To fix the platform I used 4 of the 6 screws where the access to the gear can be opened via the two covers. You need 3 new screws M3 x 25mm and 1 M3 x 10mm. Additional you will need 4 screws M3 x 10mm for the Rpi 4 case as well as 2 screws M3 x 10mm or 16mm for the “auxillary platform”. Here I mounted a GPS receiver. Also 4 M3 x 6mm thread inserts as well as 2 M3 x 4mm thread inserts are needed. The fantastic designed Rpi4 case is not mine. You will find this here: https://www.thingiverse.com/thing:3717401 Thanks a lot to “tipam”! I made all parts from white PLA but if you will use this in warm or hot areas you should at least use PETG or better filament. GERMAN: Bei der Verwendung eines Raspberry Pi an einer astronomischen Montierung kommt es gerne zum Kabelsalat. Ich habe daher eine Halterung entwickelt, welche an eine Skywatcher EQ6R Pro Montierung angeschraubt werden kann. Da ich keine andere EQ6 Montierung habe, kann ich nicht sagen, ob diese auch zu den anderen Typen paßt. Zur Montage habe ich 4 der 6 Schrauben der Wartungsdeckel gegen längere ersetzt. Benötigt werden inmsgesamt: 3 M3 x 25mm und 1 M3 x 10mm. Zusätzlich benötigt werden 4 Schrauben M3 x 10mm zur Befestigung des RPi4 Gehäuses sowie 2 SChrauben M3 x 10mm oder 16mm für die “Auxillary Plattform”. Hier habe ich einen GPS Empfänger montiert. Außerdem werden 4 M3 x 6mm und 2 M3 x 4mm Gewindeeinsätze benötigt. Das großartige Gehäuse-Design entstammt von "tipam"! Vielen Dank dafür: https://www.thingiverse.com/thing:3717401 Alle Teile sind aus PLA gedruckt. Für wärmere Regionen ist PETG oder was besseres empfehlenswert.
Statistics
Likes
5
Downloads
0