Gardena Coupling
Description
This is my attempt on providing a coupling for the Gardena system. I needed this for another project. There is a *.dxf with the profile attached, so just rotate it in e.g. Fusion 360. However, if you may need it, there is a *.pdf with the sizes as well. __If you're just looking for a coupling to print, I got you covered, too.__ It comes with a 3/4" thread (untested though). You need an O-Ring (10.5mm x 3mm) and a seal (24mm x 16mm x 3mm).
Statistics
Likes
4
Downloads
0