case for Anet ver 1.7 board
Description
I built a 3d printer and kept burning out ramps boards so I ordered an anet 1.7 board and a 12864 lcd display for it I then found no "good" cases existed for it so here is my rendition. the case fits the mainboard well and has just enough holes for the cabling. the lcd case is modified from one on thingiverse as to be able to hold a full size sd card adapter also this just slides in and is not attached to the case. the lcd on my printer hangs from a 4020 t-slot and case is made with those mounting holes I added a spot for a single 40mm fan in the top of the board case, the top is attached by a piece of filament slid in as a hinge pin
Statistics
Likes
1
Downloads
0