Jorgensen Bar Clamp Pad
Description
I lost the upper pad on my Jorgensen woodworking clamp that's about 20 years old and I found some Jorgensen replacement pads on Amazon for $13, however reviews stated they fall off after some use. I'm not sure if this will work for non Jorgensen clamps, but I think the pads are relatively the same and TPU will allow some +/- tolerance. The pad fit my clamp very tightly and I had to hammer the pad onto the clamp and now it won't slip off, but lays flat so its parallel to the other clamp face. Therefore I believe it would fit smaller clamps as well. Inside dimensions of pad are 27.55mm wide, so you can measure your clamp and see if its close.
Statistics
Likes
4
Downloads
0