Ender 3 Pro Underside PSU - Inverted
Description
UPDATE 2/16/2021 *Added V2 on Inverted Parts Someone pointed out an issue with the inverted right mount, and sure enough they were right. Fixed that and increased the tolerance of the V slot mounts to make it a bit easier to install. Also I included a Meanwell PSU in the step file which I used to align the holes slightly better. The only other change I might make is to increase the length on both of the pieces to cover the entirety of the topside of the power supply for a cleaner look, but besides that this should fit pretty well now. UPDATE: 2/6/2021 Picture has been uploaded, and the part models have been updated as there was a slight alignment issue. I have an Ender 3 Pro with the rear mounted electronics box by Teaching Tech. I wanted to add a second stepper on the Z axis, but needed my power supply to be in the front. I inverted the original part and removed the wiring guide as it is no longer needed. I also added a vent to keep any plastic from getting in the power supply. Another thing to add is this duct to keep anything from falling where the fan is. https://www.thingiverse.com/thing:4460994 This design is currently untested, but should work correctly. I am going to print the inverted version which has no need for the fan duct. I also prefer this design because the PSU fan will take in clean air.
Statistics
Likes
97
Downloads
0