Snapmaker 2.0 Camera Arm
Description
This is an adjustable Raspberry Pi camera arm specifically for the Snapmaker 2.0 3-in1. NOTE, this design is for the arm and attachment to the Snapmaker 2.0 only. You also need the files from the following Thingiverse project https://www.thingiverse.com/thing:247590 by 3dkarma to print the camera holder, the ball joint, and the socket. The arm in this project will connect to the socket from 3dkarma's project. This has been installed on the A350, but should also work on the A150 and A250. You will need four M4x8mm screws to attach the arm to the Snapmaker. You will also need M3 screws and nuts to fix the sliding portions of the adjustable arm and attach the socket to the arm.
Statistics
Likes
2
Downloads
0