Trampa motor light mount
Description
Important: I forgot to increase model size when slicing to account for ABS shrinkage. Naturally after printing it didn't fit and I decided to just file it to final dimensions. If you find the model is too small in other "non-shrinking" materials, please let me know and I alter it. you can also just give it an all axis increase by a couple of % if you don't want to wait for a rev.2. Simple little light mount that zip-tie's to the Trampa motor cage in place of the original zip-tie that holds the cables in place for the fitment of rear lights. The mount is designed to accept light weight LED lights that utilise the "square peg" mounting system. These are pretty common and cheap lights. I'd strongly recommend gluing a small square of foam or rubber to the back of the mount as this will hold it nice and tight on the cage, dampen vibration to the lights and prevent damage to the motor cage. Also Don't over tighten the zip-tie! Printed in ABS at 0.2mm layer height, 100% infill, no supports needed. as usually with smaller parts, slower is better. Print time is around 15-20mins
Statistics
Likes
1
Downloads
0