RC Plane Ski 205x38mm
Description
Check this improved version: https://www.thingiverse.com/thing:4756025 I designed this Ski for my medium sized RC airplanes. Check also the matching rear Ski : https://www.thingiverse.com/thing:4755028 There are 2 attachment point for a spring or elastic band to keep the ski pointing up a bit during flight. On a bent wire landing gear the tilt is limited by the design. A long screw in the collar can be used to limit the up-tilt. After printing, dip the front in very hot water so the PLA softens and bend it to your liking. A deep dish can act as a mold. Good luck
Statistics
Likes
5
Downloads
0