Guitar Pick and Capo Keeper
Description
I got tired of constantly knocking my picks off my music stand, so decided to fix it with a 3D print. The keeper will hold 3 picks of varying thicknesses with a minimum of about 0.3mm. Since I sometimes use a capo, I added a keeper for it as well. The whole thing straps onto a music or mic stand using a ninjaflex strap. I added a pad that gets glued into the back of the main body to add some grip, but it's not necessary for me. It adds a little to the aesthetics of the keep (in my opinion) and will make sure whatever you're attaching this to doesn't get scratched. I used a couple of small screws I had in a bin to hold the strap. One side slips into the print and the screw goes through it. The other side uses the same screw as a stud for the holes to slip over. The screws are about 10mm long and 3mm in diameter. I image an M3x8 or M3x10 would work just fine.
Statistics
Likes
3
Downloads
0