Ender 3 M8 Inductive Probe Mount Stock Hardware
Description
I couldn't find a probe mount that used the stock hardware on the stock shroud that was to my liking so I made one myself. A simple M8 inductive probe mount for the stock Ender 3 / Ender 3 Pro hotend. You shouldn't need any extra hardware to mount it. I've included the .f3d files should you want to change it. Currently the thickness of the back plate is such that my firmware requires no offset in the Y direction, your setup may be different so YMMV. My firmware offset is (-39,0,0) but you should probably measure this for yourself. If you do end up changing the back plate thickness don't make it too much thinner unless you like a floppy probe. In my experience probing is more reliable when suitably rigid. I would print it as is laying flat as the large hole seemed to print cleanly enough for the probe to slide in easily. No support needed.
Statistics
Likes
0
Downloads
0