Moff Gideon Tie Fighter in Nevarro Diorama
Description
Remix of: http://www.thingiverse.com/thing:2808940 Also a remix of some of these parts: https://www.thingiverse.com/thing:4724161 This is not screen accurate. I just wanted the Tie Fighter with folded wings and landing gear sitting in the back of my diorama. It balances well. The Tie Fighter as published will fit on an Ender3 but is a bit small for 3.75" action figures. I used my CR10 and scaled it up 130% in the photos. The Doorways are scaled for 3.75" peeps. (spoiler... If you look close, the Tie panel tips did not print... I thought the print was done so I removed them but I had run out of plastic and the sensor had stopped the print!) I used supports for the Exploded Door. Supports were used for almost entire Tie Fighter except pieces that will obviously not need them. The Gun is here and I scaled it down 70% to make it 3.75" compatible. https://www.thingiverse.com/thing:4700945 https://www.youtube.com/watch?v=h9_19S6r6mI
Statistics
Likes
23
Downloads
0