MT30 connectors and holder
Description
I installed an Amass MT30 socket into my Jumper T16 transmitter so I can properly balance charge the cells inside without ever having to take them out again. I started out by recreating MT30 male & female connectors which are so accurate they fit the real connectors, then used those models to create a mount which can hold either connector. The mount holes are 18mm apart for M3 bolts. Included are a normal front piece and one with bevels that I needed to create so it fits fine inside my T16. Holder was printed at 0.2mm layer height in PETG, PLA should be fine too, no support necessary. You can sell prints of this, but don't overcharge, and link back here. Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.
Statistics
Likes
11
Downloads
0