Three Way Pipe Elbow for Dog Bed
Description
This is a three way pipe elbow that is not hollow. I made this for the corners of a dog bed cot after needing to replace the PVC elbows. My kids jumped on the bed and split the elbows. I used 1" PVC pipe with an exterior diameter of 33.5 and inside diameter of 23.5. Only the top pipe has a center support as it was difficult to remove the build supports on the horizontal ends. Make sure that end is vertical when printing. I used sun shade material for the bed, sewed loops along the sides and slid in the pipe. Makes it easy to clean. I also included caps for the PVC legs that I printed in TPU.
Statistics
Likes
4
Downloads
0