Radiation Shield for Meteo Stations
Description
This is Radiation Shield for Temperature / Humidity sensor, designed for WeatherDuino Weather Stations, but it can also be used for any other kind of DIY Weather Station. Regarding the original design, the following changes were made: - The plates are now overlapped by a distance of 5mm, this reduces the possibility of rain to get in and cause damage on the sensor. - The size of the plates was increased to 110mm. - The size of the central hole was increased to 40mm to accommodate an optional 40mm fan. - Added a small box on the bottom of the RS, to place electronic parts like the end half of an extended I2C bus circuit - The support of the sensor was redesigned to: - Include an optional connector for the fan. - Allow the use of an additional protection chamber for the sensor You can find a complete and detailed guide about how to build this Radiation Shield here: https://www.meteocercal.info/forum/Thread-3D-Printed-Radiation-Shield-for-Meteo-Stations
Statistics
Likes
17
Downloads
0