Printdry Bezel - adds digital temp control
Description
The Print Dry is rated to 71°C, but if you put a thermometer on it, you never quite get to that temperature in the print chamber. And with the cycling, I see it bounce between 55-65°C, never quite getting to the rated temp. For drying Nylon, you need to get to 70 and hold it there for 12+ hours. So my fix is to add a STC-1000 temperature controller (~$12) so I can adjust the temperature with minimal temp cycling, place the temperature sensor in the drying chamber and void the warranty all in one fell swoop. If you are not qualified with high-voltage, cabinet wiring, you should not attempt. Proceed at your own risk.
Statistics
Likes
1
Downloads
0