ultrabook stand - vertical (open 180º)
Description
<u>Initial upload 2-15-21</u>: A stand for Dell Latitude Ultrabook for the fully open laptop (180º) to allow raising it to eye level while using an external keyboard and mouse. This configuration saves a ton of desk space. Have used every day at work and home since printing it. It's surprisingly stable and unobtrusive. Use Rev.1 0.5 mm wider gap for not as snug a fit in case the rubber feet on the back of your ultrabook are brand new and protruding too much. Please note the share alike + non commercial license. Please don't try and make money off my hard work. If you want to modify and create a derivative I provide <a href="https://www.tinkercad.com/things/4527YvcCmAo">the original Tinkercad design</a>. Please pass along the CC share alike non commercial license to any derivative work. <u>Update 4-20-21</u>: Use V2 for a faster print (3 hrs vs. 5-6 hrs) and slightly less material used. (tinkercad <a href="https://www.tinkercad.com/things/aUl7ujKnxLm">here</a>) <u>Update 8-17-21</u>: have been using both designs daily, V1 at work and V2 at home since February 2021, with zero issues with either design. It's so simple to print even I could do it, please post makes! :)
Statistics
Likes
0
Downloads
0