Propeller Driven Car
Description
The Propeller Driven Car is a vehicle that is moved by a propeller. Models for the Platform and various Motor Mount options are included. The Motor Mount is designed to hold a small DC motor, to which is attached a propeller. The size of the motor is approximately 20mm diameter and 15mm across the main flats. For the Motor Mount, ideally select the v06 model with a suitable amount of design clearance. Select an option based on the capability of your available 3D printer. If unsure, start with the model with 0.4mm clearance. 0.2mm - no dot - resin printer 0.4mm - one dot 0.8mm - two dots 1.2mm - three dots An older v05 version of the Motor Mount is also included. Supports are not required. For a filament printer, use 25% infill and 2 shells. If the motor has a loose fit, use double-sided tape, a suitable adhesive (epoxy) or a cable tie. Attach the Motor Mount to your platform using double-sided tape. The models may be used for a propeller driven car PROPC, which is available from https://www.scorpiotechnology.com.au/ If using the supplied Platform model and the suggested kit, cut the guide tubes 50mm long and the shafts 73mm long. The Motor Mount and Platform were designed in ViaCAD.
Statistics
Likes
2
Downloads
0